A 500 m long water distribution pipeline P with diameter 1.0 m, is used to convey 0.1 m/s of flow. A new pipeline Q, with the same length and flow rate, is to replace P. The friction factors for P and Q are 0.04 and 0.01, respectively. The diameter of the pipeline Q (in meters) is ______________ (rounded off to 2 decimal places).
GATE CE 2024 (S2) — Question 57
Fluid MechanicsPotential flow, Laminar and turbulent flowNAT2 marksEasy
A GATE question every morning
One real past-paper question every morning for your branch, answer hidden until you tap. Free on Telegram.
More on Potential flow, Laminar and turbulent flow
- GATE CE 2026 (S1) · Q41In a laminar flow of a Newtonian fluid through a circular pipe of radius 5 cm, the maximum velocity is found to be 2 m/s. The velocity (in…
- GATE CE 2025 (S1) · Q30For the Bernoulli’s equation to be applicable in a fluid flow situation, which of the following conditions is/are to be satisfied:
- GATE CE 2023 (S2) · Q47Which of the following statements is/are TRUE?
- GATE CE 2023 (S1) · Q44A jet of water having a velocity of 20 m/s strikes a series of plates fixed radially on a wheel revolving in the same direction as the jet…
- GATE CE 2022 (S1) · Q57Two reservoirs are connected by two parallel pipes of equal length and of diameters 20 cm and 10 cm, as shown in the figure (not drawn to s…
- GATE CE 2021 (S2) · Q22The ratio of the momentum correction factor to the energy correction factor for a laminar flow in a pipe is

