The values of parameters for the Stop-and-Wait ARQ protocol are as given below:
Bit rate of the transmission channel = 1 Mbps.
Propagation delay from sender to receiver = 0.75 ms.
Time to process a frame = 0.25 ms.
Number of bytes in the information frame = 1980.
Number of bytes in the acknowledge frame = 20.
Number of overhead bytes in the information frame = 20.
Assume that there are no transmission errors. Then, the transmission efficiency (expressed in percentage) of the Stop-and-Wait ARQ protocol for the above parameters is________(correct to 2 decimal places).
GATE CS 2017 (Forenoon) — Question 45
Computer Networks (CN)Data Link Layer (Framing, Error Detection, MAC, Ethernet Bridging)NAT2 marksMedium
A GATE question every morning
One real past-paper question every morning for your branch, answer hidden until you tap. Free on Telegram.
More on Data Link Layer (Framing, Error Detection, MAC, Ethernet Bridging)
- GATE CS 2026 (Forenoon) · Q45Consider the implementation of sliding window protocol over a lossless link, with a window size of W frames, where each frame is of size 10…
- GATE CS 2026 (Afternoon) · Q43Consider the transmission of data bits 110001011 over a link that uses Cyclic Redundancy Check (CRC) code for error detection. If the gener…
- GATE CS 2026 (Afternoon) · Q65It is necessary to design a link-layer protocol between two hosts that are directly connected over a lossless link of length 3000 kilometer…
- GATE CS 2025 (Afternoon) · Q36Suppose we are transmitting frames between two nodes using Stop-and-Wait protocol. The frame size is 3000 bits. The transmission rate of th…
- GATE CS 2024 (Afternoon) · Q23Node X has a TCP connection open to node Y. The packets from X to Y go through an intermediate IP router R. Ethernet switch S is the first…
- GATE CS 2024 (Afternoon) · Q55Consider an Ethernet segment with a transmission speed of 10 8 bits/sec and a maximum segment length of 500 meters. If the speed of propaga…

